General Safety Instructions - RED CASTLE SPORT RC Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17

General safety instructions

BEFORE USING YOUR CAR SEAT FOR THE FIRST
TIME,
READ ALL
OF
CAREFULLY RESPECTING THE RECOMMENDATIONS
AS INDICATED IN ORDER TO GUARANTEE YOUR
CHILD MAXIMUM SAFETY. IMPORTANT! KEEP FOR
FUTURE REFERENCE
WARNING
• Never leave the child unsupervised.
• The RC/RCS Car seat Group O conforms to the
European safety standard ECE R-44/04. It is
suitable for children from birth to less than 10
kgs (around 9 months).
• The RC/RCS Car seat Group O is classed in the
"universal" category of retaining devices for
children. It can be adapted on the majority of
car passenger seats. It is possible to fit the
device
correctly
in
manufacturer's vehicle handbook states that it
will take "universal" retaining devices for
children of this age group.
• The RC/RCS Car seat must always be used in the
rear facing position. It must be fixed in your
vehicle EXCLUSIVELY with a 3 point seat belt
(static or automatic) which conforms to the
ECE-16 regulation or its equivalent.
• Seat belt lengths vary from car to car. We suggest
you check that our car seat can be used in your
vehicle.
• The RC/RCS Car seat must never be installed in
front seats equipped with a
front airbag, this may prove
very dangerous.
• ALWAYS attach your baby with
the safety harness even when
you are not using the RC/RCS
car seat in the vehicle.
• The manufacturer can only guarantee the safety
of the car seat if it is used by the first time
owner. We strongly suggest that you do not use a
second hand car seat.
• Do not continue to use this car seat when used as
a reclined cradle once the child can sit unaided
• Do not use the car seat for more than 5 years.
Intensive use can cause deterioration not always
visible.
• It is dangerous to place this car seat on a raised
surface: for example, on a table...
• Never take the baby out of the car seat for any
reason while the vehicle is in motion.
• Always use the restraint system.
• When used as a reclined cradle, this car seat is
not intended for use during long periods of sleep.
All manuals and user guides at all-guides.com
THE
INSTRUCTIONS
the
vehicle
if
the
Installing the RC/RCS car seat in the
car
(Figs 1+2)
WARNING: Never install the RC/RCS car seat on the
front passenger seat if the car is equipped with a
front airbag.
This could cause death or serious
injury. If you have a front airbag use the car seat in
the rear of the car. Both in the front and in the rear
of the car, the car seat must always be used in a
rear facing position.
1. Put the handle into position 1 (see chapter on
"Adjusting the seat back and handle positions")
2. Buckle the car seat belt.
3. Feed the lap belt of the car through the guides
at the front of the car seat (located below the
car shell). (fig. 2A)
4. Then, slip the diagonal belt around the rear of
the car seat and feed it through the guide
located at the back of the car seat (fig 2B).
The diagonal belt must be positioned below the
articulation of the car seat handle (fig 2C).
5. Pull firmly on the diagonal belt to take up any
slack.
IMPORTANT: Each time the position of the car seat
back is changed, the seat belt must be tightened.
The seat belt must be positioned below the
articulation of the car seat handle. During travel,
the handle must always be in the transport
position.
WARNING: The seat belt must never be twisted.
How to adjust the safety harness
harness must be adjusted to fit the child's size. The
harness straps must go through the slots nearest to
the baby's shoulders.
• The RC/RCS car seat has two adjustable harness
heights which enables it to adapt to the child as
he grows. To change the heights of the harness,
please refer to fig 4A.
• Position the 3 point safety harness correctly and
attach the buckle
• To open and close the buckle (fig. 3)
To close: assemble the 2 parts of the buckle and
insert them into the fastener until they are secured
("click" heard).
To open: push on the red button.
• Adjusting the harness:
It is recommended that you adjust the length of the
harness to fit the size of the child BEFORE installing
the car seat in the car.
GB
(Figs 3+4)
22
Tabla de contenido
loading

Este manual también es adecuado para:

Rcs

Tabla de contenido