Idiomas disponibles
Idiomas disponibles
3.
FWD: this serves to run the cutting mechanism in working direction even if no paper has
been inserted. This is useful after a shredding process to clear any paper residue from the
cutting mechanism or remove paper residue which is too small for the AUTO sensors to
detect. The cutting mechanism can be oiled by means of a sheet of oil paper and the
cutting mechanism can continue to be run to ensure the oil is distributed well in the
mechanism.
4.
OFF: this serves to switch the device OFF and disconnect it from the power supply which
should be done if the paper basket must be emptied or the device will not be used for a
longer period of time.
This device is only intended for private use indoors. Do not use the shredder for commercial
purposes or outdoors.
Continuous use of the shredder at maximum sheet capacity for a period over 3
minutes without any interruptions leads to the motor overheating whereby the device
then switches off automatically. The "Power/Overheat" LED lights up red. Allow the
device to cool down to room temperature before putting it into operation again. (Also
refer to Averting Paper Jams and Overheating.) The "Power/Overheat" LED then
lights up green again.
Shredder capacity
GENIE 580 XCD Plus will shred ten (10) sheets of A4 size 80g/sqm paper, a CD/DVD disk or
credit card at once and will accept paper widths up to 220mm. When shredding small material
like envelopes or receipts, insert them through the middle of the feed opening.
Cautions
1. Read the operating manual before starting to use the device
2. Keep all loose articles of clothing, ties
away from the feed opening to prevent injury.
3. Keep in the OFF position when the shredder is not in use for prolonged periods of time.
4. Remove all paper clips and staples
however it is not recommended.
5. Do not place hands or fingers
, jewelry
, hair
from paper before shredding. Unit will cut staples,
into the shredder throat as serious injury could result.
- 10
-
or other small items
