Idiomas disponibles
Idiomas disponibles
Contents of Parts Bag
1 − Owner's Manual (not shown)
1 − Electric Starter Cord (not shown)
1 − Fuel Stabilizer (not shown)
WARNING: Always wear
safety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED
1 − Knife to cut carton
Figure 1 shows the snow thrower in the
operating position.
References to the right or left hand side
of the snow thrower are from the view-
point of the operator's position behind
the unit.
1740309SM
ASSEMBLY
Auger Drive Lever
Auger
Drive Cable
Crank
Assembly
Chute
Deflector
HOW TO REMOVE FROM THE
CARTON
1. Locate and remove container of
Craftsman 5W30 oil.
2. Locate all parts packed separately
and remove from the carton.
3. Remove and discard the packing
material from around the snow
thrower.
4. Cut down all four corners of the car-
ton and lay the panels flat.
5. Hold onto the lower handle and pull
the snow thrower off the carton.
CAUTION: DO NOT back over
cables.
6. Remove the packing material from
the handle assembly.
Upper Handle
T−Knob
7
1− Container 5W30 oil
Figure 1
