Craftsman 536.881501 Manual Del Usuario página 24

HOW TO REMOVE THE CHUTE
1. Remove the fasteners that secure
the chute to the top cover.
2. Remove the chute.
HOW TO ADJUST THE BRAKE PAD
IMPORTANT: An adjustment is only
necessary if the brake pad has become
loose or has been removed. To adjust,
proceed as follows:
1. Remove the top cover. See "How To
Remove The Top Cover".
2. Remove the belt cover. See "How
To Remove The Belt Cover".
1740309SM
SERVICE AND ADJUSTMENT
Idler Pulley
Screw
Brake Pad
Drive Belt
Chute
Top
Cover
3. Tie the auger drive lever to the han-
dle. This will engage the drive sys-
tem.
4. Loosen the screw and nut on the
brake pad arm (Figure 27).
5. Set the clearance between the
brake pad and the drive belt to 1/8
inch.
6. Tighten the screw and nut on the
brake pad arm.
Brake Roller
24
Engine Pulley
Belt Guide
Figure 27
Figure 26