SOLAC DC7500 Instrucciones De Uso página 9

Place the strips of used wax in the filter in tub
•
2 and set tub 2's temperature regulator to wax
melting mode (Fig. 1).
When the wax has melted, filter it, clean, then
•
remove the filter and place it under cold water.
If necessary, put back the temperature regu-
•
lator to the hair removal setting (Fig. 3). You
may continue hair removal by using the wax in
tub 2, then placing the used strips in the filter
which you have now placed into tub 1.
After hair removal, gradually top up the wax
•
with Solac wax capsules.
Set the two temperature regulators to "Min"
•
(Fig. 2), and let the wax cool down before put-
ting away the appliance.
USING ON YOUR UNDERARMS (FIG. 5)
Underarm hair tends to grow in two different
•
directions: the upper part grows upwards, and
the lower part downwards – so it will need to be
removed in two stages.
Lift the elbow up and well back to tighten the
•
skin.
Use the spatula to apply the wax.
•
For the upper part of the underarm, apply the
•
wax in layers upwards towards the elbow. For
the lower part of the underarm, stroke the wax
downwards.
USING ON YOUR BIKINI LINE (FIG. 6)
Only use on small areas at a time.
•
Holding the skin taut, use the correct end of
•
the spatula to apply a layer of wax in the direc-
tion of hair growth (generally towards the inner
thigh).
REMOVAL OF DOWNY FACIAL HAIR (FIG. 7)
For the removal of superfluous facial hair, use
•
a very gentle touch.
For downy hair on the upper lip, pull the wax
•
strips in the direction of the nose.
SKIN CARE AFTER WAXING
Skin may be slightly red after waxing. This is
•
normal, but bathing the area with cool water
will help to soothe.
Apply baby oil. Baby oil helps you remove the
•
remaining wax and you will relieve some of the
pain. Any redness will fade in an hour
If you feel a bit of irritation, don't scratch. In-
•
stead, gently press your skin with your hand.
Any discomfort shouldn't last – if it does, see
your doctor.
It is advisable to apply a tonic to dose the
•
pores and a good moisturizing cream after re-
moving hair.
If you tend to get ingrown hairs, it helps to exfo-
•
liate and moisturize your skin regularly.
CLEANING AND MAINTENANCE
Before cleaning, ensure that the device is un-
•
plugged.
The appliance does not require any specific
•
maintenance.
If occasionally, a little wax has run onto the out-
•
er surface, you can easily remove it with your
finger nail.
Do not use a sharp object to remove solidified
•
wax or clean the pot.
The pot doesn't require internal cleaning as
•
any remaining wax can be reheated for your
next waxing session.
Do not allow contact with or immerse the pot
•
in water. The wax is not water rinsable. Wa-
ter and soap will not clean the wax. Use some
baby oil.
The appliance must always be stored horizon-
•
tally.
Never submerge the connector in water or any
•
other liquid or place it under running water
CLEANING THE SPATULA AFTER EACH
USE:
Do not leave the spatula in the wax.
•
Remove excess wax from the spatula using
•
the rim of the pot.
Use some baby oil to remove the remaining
•
wax residue from the spatula
Wipe the spatula with a clean piece of dry •
kitchen cloth to remove the oil residue.
Place the clean spatula into the pot for storage.
•
IF YOU WANT TO CLEAN THE RIM OF THE
POT AFTER USE:
Ensure the pot has been switched off but is still
•
warm
Use some baby oil to remove any excess wax
•
from the rim of the pot.
Wipe the rim of the pot with a clean piece of dry
•
kitchen cloth to remove the oil residue.
Leave the pot to cool then store pot away until
•
next use
EN