Idiomas disponibles
Idiomas disponibles
3.2
CAPILLARY TUBE SELECTION
The following table gives the colour of the capillary tube to be selected based on two variables of the osmosis unit supply
water: pH and hardness. The values of these two variables must be analysed at the installation site using water analysis
apparatus or chemical reagents (not included).
The frequency with which the pre-filter needs to be changed depends on these two variables.
9.5
9
8.5
pH
8
7.5
7
°F
HARDNESS
°dH
WATER RECOVERY RATE
Temperature
5ºC
25ºC
After selecting the correct capillary tube according to the table above, set the pre-
filter change times on the control panel as shown in section (§ 4.8).
BLUE CAPILLARY TUBE = recovery of 55-60% at 15ºC
BLACK CAPILLARY TUBE = recovery of 35-40% at 15ºC (water softener recommended)
(standard)
WHITE CAPILLARY TUBE = recovery of 25-30% at 15ºC (water softener recommended)
The appliance must not be supplied with running water > 1200 ms or >35ºdH. If the
hardness of the inlet water is higher than 35ºF, a preliminary water softener must be
installed.
Remove the locking clip.
Press the mounting clips and remove the white capillary tube.
Insert the end of the capillary tube into the L-piece of the capillary tube connection.
Insert the locking clip between the connector and the clip.
<11
12--25
26--35
<5
6--15
16--20
TYPE OF CAPILLARY TUBE
White
Black
<40%
<44%
<47%
<50%
IMPORTANT NOTICE
IMPORTANT NOTICE
IMPORTANT NOTICE
36--44
21--25
Blue
<50%
<56%
EN
-
31
-
