Idiomas disponibles
Idiomas disponibles
5. If an overload is detected, an audible alarm will be sounded and the unit will emit long beep.
To correct this, turn the UPS off and unplug at least one piece of equipment from the battery
power supplied outlets. Make sure the circuit breaker is depressed and then turn the UPS on.
6. To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.
7. To store the UPS for an extended period, cover it and store with the battery fully charged. While
in storage, recharge the battery every three months to ensure battery life.
8. For pluggable equipment, the socket-outlet shall be installed
near the equipment and shall be easily accessible.
9. Do not lie or mount the UPS down on its side to ensure the
battery life.
Definitions For Illuminated LED Indicators
Power ON
On
Flash when
Beeps twice every
Beeps
30 seconds
Rapid Beeping
Flash when
Beeps
1/2 second
On
Constant tone
Off
Constant tone
Off
Constant tone
Alarm
Off
Normal
Utility Failure - Battery Mode
The UPS is providing power to battery and surge
protected outlets from its battery.
Utility Failure - Low Battery
every
The UPS is providing battery power. Rapid beeping
indicates the unit will run out of power shortly.
Overload - Occurs when connected equipment
exceeds the listed capacity of the UPS. Turn the UPS
off, unplug at least one piece of equipment from battery
outlets, reset the circuit breaker and turn the unit on.
Charge Fault - In line mode, the battery charging
voltage is too high or too low.
Utility Failure - The frequency is beyond 47-63 Hz. The
UPS will not turn on in line mode.
CONDITION
7
