AmazonBasics B073Q48Z95 Manual De Instrucciones página 4

Idiomas disponibles

Idiomas disponibles

Basic Operation
1. Battery and Surge Protected Outlets
The unit has three battery and surge protected outlets to ensure temporary uninterrupted
operation of your equipment during a power failure. (Do not plug a laser printer, paper
shredder, copier, space heater, vacuum, sump pump or other large electrical device into
the "Battery and Surge Protected Outlets." The power demands of these devices will
overload and possibly damage the unit.).
2. Full-Time Surge Protection Outlets
The unit has three surge suppression outlets to provide surge and line noise protection.
3. Power Switch
To turn the UPS on, press the power button for approximately 2 seconds - you will hear a
constant tone (1 second) - and release after a short beep.
To turn the UPS off, press the power button for approximately 2 seconds - you will hear a
constant tone (1 second) - and release after two short beeps.
Quickly press the POWER button twice can turn off or turn on the audible Alarm. The default
setting is for the Alarm On.
To turn the alarm off, press the power button twice. You will hear two short beeps when the
alarm is turned off.
To turn the alarm back on, press the power button twice. You will hear a short beep when the
alarm is turned on.
*When the alarm is turned off, no audible notification when the UPS reaches a (low)
battery state.
4. Power On Indicator (green)
This LED is illuminated when the utility power is normal and the UPS outlets are providing
power, free of surges and spikes. When In the event of a complete power loss, severe
brownout, or over-voltage, the UPS will turn to battery mode and the LED will flash.
Please refer to the following "Definitions for Illumination LED Indicators" for more information.
5. Circuit Breaker
Located on the side of the UPS, the circuit breaker serves to provide overload and fault
protection.
6. Outlets Designed for AC Adapters
The UPS unit has two widely-spaced outlets, so AC power adapters can be plugged into the
UPS without overlapping or blocking adjacent outlets.
4
loading