Idiomas disponibles
Idiomas disponibles
❸
Step
Test the pager
Trigger the connected accessory
●
The pager will sound
●
The respec ve zone indicator light will flash
●
To stop the sound, press any of the two bu ons on the pager
●
IMPORTANT: it is always advised to test the opera ng range within your
building or work environment.
6. Indica on of low ba eries
Product
CruxCare C1 Pager
CruxCare call bu ons red & blue
(CCCB01R CCCB02B)
Tiiwee window & door sensor (TWWS03) LED light of the sensor is blinking or is con nuous lit
Tiiwee PIR mo on sensor (TWPIR02)
7. How to replace ba eries
CruxCare C1 pager
Take the pager out of the silicone sleeve. If you used the screw to secure the rear
panel, remove the screw at the bo om. Slide off the back panel and replace the
ba eries with 3x AA-size 1.5V alkaline ba eries.
IMPORTANT: do not use rechargeable ba eries. Only use alkaline ba eries.
CruxCare call bu ons
Open the bu on at the site where the li le cutout is visible at the rim of the call
bu on. This can be done with the p of a knife or a screwdriver. You will now see
the ba ery. Replace the ba ery with a new CR2450 (3V) ba ery. Please note the
correct polarity. Close the call bu on by placing the cutouts opposite each other
and pressing the two halves together.
Low ba ery indica on
Two consecu ve beeps every 20 seconds
accompanied by a flash of all LEDs
No low ba ery indica on. Replace ba eries every
six months
The indicator light in the front lights up con nuously
8
Tiiwee window & door sensor
Remove the screw at the bo om of the sensor. Now slide the sensor upwards and
remove it from the back panel. Take out the old ba ery and replace it with a new
AAA alkaline ba ery. Please note the correct polarity of the ba ery. Slide the
sensor on the back panel and secure it with the screw at the sensor's bo om.
Test the sensor.
Tiiwee PIR mo on sensor
Open the back panel and replace the ba eries with 3x AAA ba eries.
8. Rese ng the C1 pager to factory se ngs
Use this procedure when you want to assign an accessory to a different zone.
Remove one of the 3 x AA ba eries
●
Press and hold the Connect-bu on while inser ng the ba ery again
●
You will hear ten beeps, followed by ten short beeps
●
Release the bu on
●
A er the factory reset, the pager will switch on again automa cally
●
IMPORTANT: A er a factory reset, all accessories will need to be connected
again. Please refer to chapter 5 for accessory pairing instruc ons.
IMPORTANT: A er the factory reset, the volume se ng will be at the highest level.
9. Customer service
If addi onal support is required, please visit
supplementary support material as well as our support videos in your language.
You can also contact us at
info@ iwee.com
ques ons, but mostly s ll on the same day. We provide a two years warranty on
all our products.
CruxCare products are manufactured in China.
®
CruxCare and iwee are registered brands owned by Tiiwee B.V.
®
®
www. iwee.com
. Here you can find
. We respond within 24 hours to all
9
