CruxCare C1 Manual Del Usuario página 5

Tiiwee PIR mo on sensor TWPIR02
This sensor can be used to guard rooms or areas. When the pa ent moves in the
observed area, a signal will be sent to the CruxCare C1 Pager.
Detector window Indicator light On/Off switch
Power supply: 3 x AAA alkaline ba ery or by an external 5V/1A DC power supply
connected through the micro-USB port. The ba eries can stay inside the sensor
while the external power supply is connected and in use. They will work as a
power backup in case of 220V power failure. The power adaptor is not included
with the product.
Detec ng Range: 4-8 m/110 degrees angle
Detector Size: 106x67x45mm
Housing material: ABS
Radio-frequency: 433 MHz
Micro USB port Wall mount plate
6
5. Connec ng accessories
IMPORTANT: if you have purchased a product containing the pager and an
accessory, the accessory is already connected. The pairing procedure is only
needed for addi onal devices or if you want to change the zone for an accessory
that is already connected.
❶
Step
Enter Programming mode
Ensure that the pager is switched on.
●
Press and hold the Connect-bu on un l you hear a beep.
●
The pager immediately goes into pairing mode for the red zone.
●
Select the desired zone by short-pressing the Connect-bu on again.
●
The respec ve zone indicator will be shown.
●
IMPORTANT: If no bu on is pressed or no accessory is connected, the pager will
automa cally exit the programming mode a er 20 seconds. If this happens, just
enter programming mode again as outlined in Step 1.
❷
Step
Pair with compa ble devices (use selected CruxCare or Tiiwee accessories only)
While the pager is in programming mode (respec ve zone indicator light is on,
●
step 1), trigger the device you would like to connect.
You hear two short beeps, and the zone indicator light will flash twice to
●
acknowledge successful pairing.
You can now con nue to add more devices to the same or other zones.
●
Exit the programming mode by short pressing the volume bu on.
●
IMPORTANT: If you hear only one beep during pairing, it means that the
accessory was already paired to the pager previously. If you want to change the
se ngs for this accessory, reset the pager and connect the accessory to the zone
you wish to.
7