FUXTEC FX-PS152 Manual De Instrucciones página 54

Original Bedienungsanleitung FUXTEC FX-PS152 / FX-PS162_de_en_fr_ita_es_rev07
WARNING
The spark plug must be screwed down tightly; otherwise, the engine runs hot and is
damaged.
Sharpen the shielded knife
1. Remove cutting blade (E) from a protective shield (F).
2. Clamp the knife in a vice. Sharpen the knife with a
flat-file. Please make sure that you maintain the angle of
the cutting edge. Only move the sharpening knife in one
direction during the sharpening process.
35. Storage of the device
WARNING: Failure to follow these steps may result in the formation of
deposits in the carburetor. This will make starting difficult and cause
permanent damage
1. Perform all general maintenance as described in the maintenance section of your
user manual are recommended.
2. Clean the exterior of the device, drive axle, protective shield, and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After draining fuel, start the engine.
5. Let the device run in neutral until the device stops on its own. This will clean the
carburetor of fuel.
6. Let the device cool down (about 5 minutes).
7. Use a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter cord
slowly several times to coat internal components. Replace the spark plug.
9. Store the device in a cool, dry place away from any ignition source such as an oil burner,
water heater, etc.
TRANSPORT PROTECTION
Make sure that the device is well-secured during transport to avoid fuel loss, damage, or
injury. Install transport protection for metal sheets during transport and storage
54