Idiomas disponibles
Idiomas disponibles
9. Connect the high temp Silicone Tube
(12) to the Mounting Nipple (11) and
secure the tubing using the Hose Clips
(13) (fig. 3D).
3D
11
12
Usage and maintenance
Usage
Pull the handle(s) forward to turn on the
water supply. Both valves will stay in the
"ON" position until rotated back to upright
position.
Note: The spout has a 360° swivel
capability.
Warning: Do not operate both handles
at the same time, as this can build up
pressure in the heating tank causing the
bladder to expand and eventually burst.
Such damage is not covered by the
warranty.
Seasonal Shutdown: If you plan to be
away from home for extended periods
of time, refer to the filtration system
and/or heating tank system instructions
(if applicable) under the Winterizing or
Seasonal Shutdown sections to prevent
system failures.
10. Connect the other end of the high
temp silicone tube to the heating tank
outlet as outlined in the heating tank
instructions.
Note: All tubing provided with the faucet
is intended to be longer than will be
necessary to make the connections to
the heating tank. It is recommended to
cut these tubes to the proper length to
remove any unnecessary loops or low
spots in tubing after installed.
11. Turn on the water and check for leaks.
13
General maintenance
Do not use harsh detergents, solvents,
chemical agents, especially CHLORINE
based cleaners, metallic sponges, etc.
that could harm the surface and damage
the finish.
Clean only with soft sponge and soapy
water.
9
EN
