Turning On And Off; Cleaning Modes & Movement Patterns - Vileda VR 302 Manual Del Usuario

1. STARTING UP
To turn your VR 302 on, switch the ON/OFF button on the right side of the device. You will hear a welcome melo-
dy and the LED display will be illuminated. To start the standard or intensive cleaning cycle press the "POWER" or
"MAX" button on either the LED display or the remote control.
To pause the robot press the "POWER" button again.
NOTE: when starting the robot, always place it in the middle of a room or surface, at least half a meter away from
any cliffs.
2. STANDBY
Standby means, the robot's main power is turned on, and the robot is ready to use. Through one of the following
methods, you can change into standby mode:
• When robot is cleaning, press "POWER" button on main body to pause robot and enter standby mode.
• When cleaning, press the ON/OFF on remote controller to pause the robot to enter standby.
3. SLEEP MODE
In sleep mode, the robot's display will turn dark (but robot is not powered off).
In order to save power, you can turn the robot into sleep mode from standby mode via either of the following methods:
a. Long press "POWER" button on main body for 3 seconds, robot will enter into sleep mode.
b. Robot will automatically enter sleeping if power is low when in standby mode.
4. POWER OFF
To turn the device off, switch the ON/OFF button on the right side of the robot.
3.3 Cleaning modes & movement patterns
THE ROBOT IS EQUIPPED WITH FOUR DIFFERENT CLEANING MODES
1. Eco Cleaning Mode
2. MAX Cleaning Mode
3. Spot Cleaning Mode
4. Scheduling mode

3.2 Turning on and off

The robot cleans the room automatically and adjust its
cleaning pattern according to the room's architecture. The Eco
mode balances energy consumption and the cleaning
performance.
The robot will increase it's suction power and slow down in
speed to reach the peak performance and clean dirtier areas
thoroughly.
NOTE: On carpet it is recommended to always use MAX mode
to achieve best results.
In this mode, the robot will clean intensively in a spiral way with
more suction power. This mode is created for picking up dirt
on a limited area of around 1,20 m x 1,20m. The mode lasts 90
seconds.
When activated in standby the robot will start and stop at the
same position. When activated while the robot is already
cleaning the robot will continue cleaning after the Spot
cleaning mode has finished.
After scheduled, the robot will leave the dockingstation and
start working daily in the Eco mode at the scheduled time.
G
11