Lindy 38344 Manual De Usuario página 8

User Manual English
15- CAT OUT: HDBaseT output port. Connect a compatible HDBaseT receiver using a single Cat.6 or
above cable for all data signals. Please do not connect to a network port.
16- HDMI IN: Connect to an HDMI source device.
17- HDMI OUT: Connect to an HDMI local display.
18- 3.5mm IN/OUT: Audio embedding/de-embedding port, connect to an analogue audio output/input
using a 3.5mm cable.
19- TOSLINK OUT: Connect to a digital TosLink (Optical) Output using an optical cable.
20- IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
21- IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
22- RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 commands.
Receiver Front and Rear
1- POWER LED: Indicates Power.
2- LINK LED: This will illuminate when the connection between transmitter and receiver is active; this will
flash when the units are in low power mode.
3- VIDEO LED: This will illuminate if the video is encrypted; this will flash if the video is not encrypted.
4- ARC LED: This will illuminate when the ARC function has been switched on, it remains off if it's on
SPDIF mode.
5- TOSLINK LED: This will illuminate when the TOSLINK function has been switched on, it remains off if
it's on ARC mode.
6- SELECT button: Push the button to switch between ARC and TOSLINK mode.
7- HOST/DEVICE USB switch: Switch left to enable the USB HOST mode and connect a source to USB
HOST port using a USB Type A-B cable; switch right to enable the USB DEVICE mode and connect USB
peripherals to USB DEVICES ports.