Technical specifications
Model:
Nominal load:
Lifting height:
Total length: ca.
Own weight: ca.
Lifting height with rated load (mm):
Design conforms to the EN1494/A1:2008
PRIOR TO OPERATION
Air may become trapped in the hydraulic system during transit.
To purge air:
1. Open release valve by turning handle counterclockwise.
2. Pump handle rapidly 4 full strokes. This will expel air that may have entered oil passages during transit.
3. Close release valve by rotating handle clockwise and pump handle.
4. If lift arm raised, jack is ready for use. If not, repeat this procedure.
OPERATING INSTRUCTIONS
IMPORTANT! Before attempting to raise a vehicle, check vehicle service manual for recommended lifting
surfaces.
1. To raise load: Close release valve tightly (by turning handle clockwise) DO NOT OVERTIGHTEN. Position
jack under load so that saddle will contact load firmly and load is centered so it cannot slip. Operate jack
handle until saddle approaches the load. Once again check to see that saddle is correctly positioned. Raise
load to desired height. Place jack stands of appropriate capacity under the vehicle. DO NOT CRAWL UNDER
VEHICLE WHILE LIFTING VEHICLE OR PLACING OR REMOVING JACK STANDS ! Place jack stands at vehicle
manufacturer's recommended lift areas that provide stable support for the raised vehicle.
2. To lower load: Open release valve VERY SLOWLY (by turning handle counterclockwise). When release valve
is opened, saddle and load will be lowered. Lower the vehicle slowly so as not to shock load the Jack
stands. Once repairs are completed, raise vehicle enough to remove jack stands. Lower vehicle very slowly.
CAUTION! Keep hands or feet away from the hinge mechanism of the jack.
ITEM No.
1
2
3
4
5
6
7
8
80927
max. 2 tonnes
min. 125 mm a max. 380 mm
537 mm
11,8 kg
125-380
6
DESCRIPTION
Front wheel assembly
Saddle
Handle fork
Handle assembly
Release valve
Power unit assembly
Rear caster assembly
Lifting handle
80586
max. 2 tonnes
min. 135 mm to max. 340 mm
447 mm
8,7 kg
135-340