Probuilder 43630 Manual De Instrucciones página 26

The LED (A) on the charger lights up red
during charging.
When the LED on the charger lights up green
again, the battery is fully charged.
A full charge takes approx. 1 hour.
Disconnect the charger plug from the mains
and insert the battery into the drill. Make
sure the release button engages so that the
battery is fi rmly in place.
B
Pic B
You can check the battery charge status by
pressing in the button at the back of the
battery. The LEDs (B) on the battery light up
to indicate the battery charge status:
26
Charge
status
100%
>67%
>30%
Preparation
Changing bits
Switch the direction selector (4) to its centre
A
position.
Pic .A
Turn the chuck (1) anticlockwise by hand to
open the jaws of the chuck.
Insert the required drill bit into the chuck and
retighten.
Check that the bit is in the centre of the
chuck and is secure.
Selecting direction
Select direction (left or right) using the
switch (4). The switch must not be moved
while the chuck is rotating!
If the switch is placed in the centre position,
the on/off button cannot be pressed in and
the drill cannot be started.
Selecting speed
Push the gear selector (3) to position 1 to
select low speed and high torque, or position
2 for high speed and lower torque.
The gear selector must not be moved while
the chuck is rotating!
Selecting torque
Select the torque by turning the torque
selector (2) to the required position. The
higher the setting, the higher the torque
applied. To drill, turn the torque selector to
the position with the drill symbol.
Display
3 LEDs lit
2 LEDs lit
1 LED lit
Pic B