Technical Data; Special Safety Instructions - Probuilder 43630 Manual De Instrucciones

CORDLESS DRILL
Introduction
To get the most out of your new cordless
drill, please read through these instructions
and the attached safety instructions before
use.
Please also save the instructions in case you
need to refer to them at a later date.

Technical data

Battery:
Voltage/frequency, charger:
Charging time:
Speed, 1st/2nd gear:
Torque settings:
Max. torque:
Chuck:
With brush-free motor with electronic brake,
metal chuck and LED work light
Including charger, battery and belt clip
24
18 V 2.0 Ah Li-ion
230 V~ 50 Hz
1 hour
0-500/1,700 rpm
16+1
50 Nm
Self-tightening 13 mm

Special safety instructions

Check that the air vents on the cordless drill
are not blocked.
Do not use damaged or worn drill and screw
bits and always select the correct type of bit
for the job.
Secure small items in a vice or similar. Never
hold the item in your hand!
Check for concealed power cables, pipes, etc.
in the items or surfaces you are going to drill.
Make sure that the drill does not damage any
objects under or behind the item, e.g. when
drilling into walls.
Place a piece of scrap wood under the item if
possible.
The drill must not be in contact with
anything when it is started.
Drilling certain materials can produce
harmful dust. Always wear a mask.
Ensure the drill has completely stopped
before changing direction.
Never put the drill down if the bit is still
rotating. Wait until it has stopped completely
before putting it down if you are not going
to use it again.
Avoid touching the drill bit immediately after
use. It may be very hot.