Idiomas disponibles
Idiomas disponibles
Installation - Safety Guidelines cont.
These instructions are for general guidance. Installation procedures may vary depending on
caravan type.
Use appropriate support! Working under a vehicle without appropriate support is extremely
dangerous. If you are fitting the mover system yourself, it is advisable that the installation is
conducted by two people, as the mover will need to be raised up to the bottom of the
caravan's chassis before the clamps can be installed.
Remember to complete the product registration form with the serial numbers of each motor
assembly prior to fitting (see details within the Guarantee section of this manual).
Installation - Electrical/Electronic Components
This manual is a follow on from the installation guide provided with your caravan
movers. Please read the installation guide thoroughly prior to attempting anything
described in this Electronics installation guide and user manual.
Several items required for electrical/electronic installation are supplied alongside your motor
movers. For reference to these items described in this manual, see the 'package contents'
section of your installation guide.
Before attempting any electrical work, be sure to isolate the 12V supply from the battery and
ensure any 230V electricity supply is disconnected.
Find a suitable place to mount the Electronic Control Unit (2), such as a storage area, under a seat or
a bed. Make sure this place is dry and close to the battery (30 cm to 60 cm). Affix the supplied antenna
(3) to the rear screw thread at the rear of the electronic control box prior to mounting. The unit can
then be mounted on a flat base (horizontal) or on a wall (vertical). When choosing location, ensure
that the unit cannot easily be damaged. Fix the Electronic Control Unit (2) into position with four of the
screws provided with your mover fixings. If the length of these screws is not suitable for the desired
location/material, please substitute as appropriate.
See Fig.4, remove the front cover as indicated. This will allow access to the various terminals on the
electronics box. A cross head screwdriver will be required to screw down ring terminal connectors.
Drill a 25mm hole through the floor of the caravan approximately 150mm centrally in front of the
control unit (2) terminals.
Take care to avoid any chassis members, gas pipes and electrical wires when drilling the
required holes and fixing components to your vehicle.
Study Fig.5. The wiring diagram (Fig.5 depicts the wiring route when the motor units are installed on
the FRONT wheels/axle, facing the rear of the trailer. Fig.6 displays the polarity of the terminals on the
various mover variants. Note that these locations remain the same regardless of whether the motor is
the left or right side mover.
EN 11
