Idiomas disponibles
Idiomas disponibles
ATTENTION!
After an accidental collision with a foreign body,
check that the system BBC not present
anomalies.
Engine lubrication
Consult the safety and operation instruction of the engine
manufacturer.
Traction cable regulation (Fig.04)
The transporter engagement cable must only be regulated in
the event that, with engine running, on handle operation the
wheels fail to provide a prompt response and it seems that
the clutch is slipping.
Replacement transmission oil
MOBILFLUID 424 / API GL 4
45 ml = 500 h
ISTORAGE PROCEDURE
8)
Storage procedure
Take the following steps to prepare your mower for storage at
the end of the mowing season. Refer to the engine manual
for directions for preserving the engine. With the spark plug
wire disconnected from plug, turn the mower on its side and
thoroughly clean underside of deck. Scrape away
accumulation of grass with putty knife and/or wire brush first,
then wash down with water from a hose.
MULCHING
9)
1)
For grass cutting in Mulching mode, it is necessary to
check that the grass height does not exceed 20 cm,
viceversa it is necessary to remove the Mulching closure
element and mount the grass collection sack.
2)
When working in the Mulching mode, make sure that the
grass is dry and that the blade is well sharpened in order
to ensure that the cut grass does not accumulate
underneath the volute of the casing.
3)
Function:
a -
Position the Mulching closure element in the grass
expulsion compartment (Fig.13 - 14). For aluminum
models also fit the mulching blade.
ATTENTION! Make sure that the motor is off and
that the spark-plug cover is detached.
LABEL RECOGNITION
10)
Regulation is undertaken by loosening the 2 nuts, turning the
upper nuts twice in anti-clockwise direction, and then re-
tihtening it with the counter-nut, should the operation not be
effective it can be repeated.
ATTENTION !
Excessive pressure on the cable may result in the
breakage of the transmission.
After regulation always check that, with engine off, and pulling
back the machine without operating the transporter handle,
that the rear wheels rotate freely.
CAUTION: Avoid spraying water into exhaust or air intake
while washing deck - tape openings closed to prevent this.
Clean external surfaces of mower and allow to dry, then
lubricate all exposed metal surfaces with a light coating of oil
to prevent corrosion. The grass catcher may be washed in
detergent; allow to dry thoroughly after washing. Store mower
during off season in a storage shed or dry area protected
from weather.
b -
The cutting height shall be set not lower than 50 mm.
c -
Start up the motor and proceed with normal grass
cutting.
4)
After operation in the Mulching mode it is advisable to
undertake thorough cleaning to remove any cut grass
residue. For this operation, connect the water to the quick
graft. Turn on the tap and start the engine.
Do the same thing after the normal cut, without the
grasscatcher.
ATTENTION!
Do not open the water tap before connecting the
tube.
EXAMPLE
DATA
ACTIVE
21
