espresso JET Manual De Uso página 19

START UP
Remove the machine from the packaging and place it on a stable
surface that can sustain the weight and near a suitable electrical
socket.
Warning
Keep the packaging and all its parts for future transport.
The warranty is void without the original packaging.
Warning
Leave at least 10 cm around the machine on all sides.
Do not cover the machine with clothes or protective clothes.
FILLING THE TANK
Warning
The operations described below must be performed with the
machine disconnected from the electrical network.
C
D
- Lift the water tank compartment cover (A);
- remove the two water suction pipes (B) from the mouth of the
water tank (C) and extract it from its seat;
- rinse it with abundant running water and dry it on the outside;
- fill it with approximately 2 litres of drinking water, preferably with
a low limescale content (less than 25° f - French degrees);
- put the water tank back in its seat;
- fit the limescale filter (D) into the longer hose (B);
- reinsert the pipes previously removed in the holes provided in
the tank;
- replace the cover of the water tank compartment.
Warning
Do not exceed the water tank's capacity.
Make sure that the outside of the tank is not wet. If necessary,
dry it with a cloth.
CONNECTION TO THE MAINS
THINGS TO CHECK BEFORE CONNECTING
Warning
A
The power supply voltage of the machine may not be modified by
the user. Before connecting to the mains, check that:
the mains voltage corresponds to the power supply voltage of
the machine, indicated on the identification plate on the rear of
B
the machine;
- that the plug of the machine's power cable connection fits into
the socket;
- that the socket or the electrical network is connected to a device
protecting against indirect contact (circuit breaker) with a fault
current I∆n not greater than 20mA;
19
EN
user's Manual