Garland CEPA 130 SBW Manual De Instrucciones página 20

English
Store battery-powered power tools with the battery
disconnected and out of the reach of children.
2.3. SAFETY OF THE WORK AREA
Keep the work area clean and work in good lighting.
Messy and dark areas cause accidents.
Do not operate this machine in explosive
atmospheres as well as in the presence of
flammable liquids, gases and dust. Electric
machines create sparks that can ignite dust or
fumes.
Keep curious and children away while operating this
machine. Distractions can cause you to lose control.
Make sure that children, people or animals do not
enter your work area.
2.4. ELECTRICAL SAFETY
Use only Garland batteries for this machine.
Use only the Garland charger to charge Garland
batteries. The use of a different battery or charger
may cause the battery to explode and risk of fire.
Be sure to connect the charger to a 100V-240V and
50-60Hz DC power supply.
The electrical plug on the charger of this machine
must match the base of the power outlet.
Never modify the plug in any way. Unmodified plugs
and matching bases will reduce the risk of electric
shock.
When using the battery charger avoid body contact
with grounded surfaces such as pipes, radiators,
electric ranges and refrigerators. There is an
increased risk of electric shock if your body is
grounded.
Do not expose this machine, charger, or battery to
rain or wet conditions. The water that enters them will
increase the electric shock irrigation.
Do not abuse the cable. Do not use the cable to carry,
lift or unplug the charger. Keep the cable away from
heat, oil, sharp edges or moving parts. Damaged or
tangled cables increase the risk of electric shock.
Never use this charger with a damaged cord or plug.
Before connecting the charger, check the plug and
the cable for damage. If you discover any damage
send your machine to a technical service for repair. If
the cable is damaged or broken, unplug immediately.
Damaged or tangled cables increase the risk of
electric shock.
Replacing the plug or power cord should always be
done by the manufacturer or its technical support
service. It is recommended to connect this charger to
a residual differential device whose tripping current is
less than or equal to 30mA.
Never use a damaged, non-compliant docking
station for this charger.
Disconnect the charger from the power supply when
not in use to prevent damage in case of mains
overload.
Charge the battery only with the charger supplied
with the machine, in a dry place with a temperature
between 0º C and 40º C.
Do not attempt to tamper with or open the battery and
/ or charger.
Do not short circuit the battery and be careful when
handling it so as not to accidentally short circuit it with
conductive elements such as rings, bracelets, keys,
etc. When the battery short-circuits, the temperature
rises and can explode or burn.
20/84