ICY BOX IB-176SSK-B Manual página 4

1. Features
• 1x 3.5" SATA or SAS HDD/SSD in 5,25" bay
• Trayless and easy installation
• Aluminum and Stainless Steel
• Intelligent Fan Control (4x4x1cm fan)
• Audio + LED Alarm for fan failure and overheating
• Individual Power-Switch
• Hard disk capacity not limited
• SATA I/II/III host interface 6.0 Gbit/s
• With key lock to secure the HDDs
• LED for power, HDD access
• Patented NSS SATA/SAS connector supports 50.000 times Hot Swap
2. Packing Content
1x IB-176SSK-B-B, 1x SATA data cable with security clips, 2x keys, 4x screws
3. Front & Rear Panel
1. 2. 3.
1. Alarm Mute Button with Alarm LED (red/orange)
2. Power Button with LED for power and Access (blue)
3. Key Lock
4. Door Handle
4. Installation
1. Remove the cover of an empty drive bay of 5.25" space.
2. Smoothly insert the IB-176SSK-B-B into the bay and push it inwards until its screw hole is aligned with the hole of the
bay.
3. Use two screws on each side to securely hold the device. The installation-direction must be right: Lock at the left side!
4. Connect the SATA 15Pín power cable to the power supply of your PC.
5. Connect the SATA 7Pin data cable to the connector on the rear side of the IB-176SSK-B-B, another end to the
SATA 7Pin data port on the main board (or SATA RAID card) of your PC.
6. Unlock and pull the door handle
7. Place the HDD (label side up) into the IB-176SSK-B-B, close the door to push the HDD into the IB-
176SSK-B-B until the door is locked
4.
IB-176SSK-B
1. 2.
1. Alarm Buzzer
2. SATA Power Connector (15Pin)
3. SATA DATA Connector (7pin)
4. Fan Mode Switch
4
3. 4.