Idiomas disponibles
Idiomas disponibles
NOZZLE CLEANING INSTRUCTIONS
Clogging or partial clogging of the nozzle can significantly reduce water flow and
cause the unit to pulsate while spraying. To clean the nozzle:
• Turn off the device and disconnect it from the power supply.
• Close the water supply. Relieve the pressure from the hose by squeezing the
trigger 2-3 times.
• Disconnect the tip from the gun.
• Rotate the nozzle to a position that produces a narrow spray pattern.
• Using the included tip cleaning tool or an unfolded paper clip, insert the wire into
the nozzle opening and move it back and forth until the debris is removed (see fig.
5).
Figure 5 - Insert the tip cleaning tool into the nozzle opening and move it back and
• Remove additional dirt by backwashing the nozzle with water. To do this, touch the
end of the garden hose (with running water) with the tip of the nozzle for 30-60
seconds.
ANGLE OF THE SPRAY ON THE CLEANED SURFACE
When water is sprayed onto a surface, the maximum impact force is generated when
the water hits the surface perpendicularly. However, this type of spraying tends to
Figure 4 - Wide stream
forth until the debris is removed
