Sparco MAX S2 Manual Del Usuario página 7

DASHBOARD OPERATION
Speedometer
Indicates the current speed.
Also displays error codes when faults are detected.
Mode Selection
3 driving modes are available,
which respectively are:
- ECO mode (enegry-saving)
- D mode (Standard)
- S mode (Sports).
Single click the power button to switch the mode.
Power Switch
Long press to power on; then the scooter
information will be displayed on the dashboard.
Long press to power o .
ERROR CODE
1 : Motor Hall Fault
2 : Motor DC current sample Fault
3 : Motor shunt current sample Fault
4 : Overvoltage Fault
5 : OverCurrent Fault
6 : OverTemp Fault
7 : Undervoltage Fault
8 : Communication Fault
9 : ECU Power on/Power o Fault
10 : Motor No Hall Sensor Fault
11 : Motor Hall A Sensor Fault
12 : Motor Hall B Sensor Fault
13 : Motor Hall C Sensor Fault
14 : ECU A shunt High Mosfet short circuit
15 : ECU A shunt High Mosfet circuit cut o
16 : ECU B shunt High Mosfet short circuit
17 : ECU B shunt High Mosfet circuit cut o
18 : ECU C shunt High Mosfet short circuit
19 : ECU C shunt High Mosfet circuit cut o
20 : ECU A shunt current sampling Fault
LED Lighting: Double-click the power
button to turn on.
Over-temperature Display: If the internal temperature
of the controller and motor is too high during the
operation of the vehicle, the panel will promptly
display an over-temperature alarm.
Failure Alarm: When the controller fails,
the alarm symbol will light up to warn.
Left and right turn signals: the left turn signal
lights up when turning left, and so is the right side.
*All MAX S2 Pro models.
Power display: when the power is more than 85%,
the display is full, and it will gradually go out
as the power drops.
Bluetooth: A solid Bluetooth icon indicates that
the vehicle is connected to a mobile device.
You can view the vehicle status after connecting
to the APP via Bluetooth.
21 : ECU B shunt current sampling Fault
22 : ECU C shunt current sampling Fault
23 : ECU Bus shunt current sampling Fault
24 : Motor A shunt cable cut o
25 : Motor B shunt cable cut o
26 : Motor C shunt cable cut o
27 : ECU Over Voltage
28 : ECU Under Voltage
29 : ECU Mosfet Over temperature
30 : ECU Mosfet under temperature
31 : ECU Mcu Over temperature
32 : ECU Mcu under temperature
33 : Motor Over temperature
34 : Motor Under temperature
35 : ECU Shunt Over current
36 : ECU Bus Over current
37 : Motor Stall
38 : Speed too High
39 : Accelerator not under control
(Accelerator be press before scooter power on)
40 : Main battery Lock Fault
41 : Stand sitck sensor Fault
42 : Accelerator voltage Low
43 : Accelerator voltage High
44 : Left Brake voltage Low
45 : Left Brake voltage High
7