Idiomas disponibles
Idiomas disponibles
PLEASE, FOLLOW THESE STEPS TO EASILY PRIME YOUR PUMP.
STEP 8
Connect your discharge line, using a ball
valve, as illustrated. (photo 1)
Fill the suction line with water and connect it to
STEP 9
suction inlet (Photo 1).
Remove the plug of the priming pipe and fill
STEP 10
the pump body with water (Photo 1).
Screw the plug to the priming pipe using teflon
STEP 11
tape.(photo 2)
step 11
STEP 12
NOTE: After installation, if the pump is cycling "on-off" and/or comes on when you are not visibly using water,
the pump is not defective. It means you have a leak on the discharge side of the pump. The leak must be
localised and needs to be repaired. If you need assistance to determine same, please call 1-800.361.1820.
The pump is warrantied by the manufacturer and you must call us to determine procedures. The pump
cannot be returned to the point of purchase without our prior consent.
6
PRIMING INSTRUCTIONS
step 10
step 9
Connect the pump. The pump should
delivered water to the plumbing line within
30 seconds. If not, unplug the pump and
repeat from step 10. In accordance with
the lenght of your suction line, you may
have to repeat these steps a few times.
PHOTO 2
step 8
1'' flexible hose
for 3 to 5 ft.
PHOTO 1
step 12
