Idiomas disponibles
Idiomas disponibles
Installation (continued)
5
Sealing the fixture
□ Apply silicone sealant ( not included) between the fixture body (B) and
the wall for additonal protection against water and dust.
□ Restore power at the electrical panel. Turn on the light switch to activate the fixture.
Care and Cleaning
CAUTION: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse
from the fuse box.
□ Clean the fixture with a soft, dry cloth.
□ Do not use cleaners with chemicals, solvents, or harsh abrasives.
□ Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light fixture.
Troubleshooting
Before doing any work on the fixture, disconnect power to the light fixture.
WARNING:
Minor problems often can be fixed without the help of an electrician.
Problem
The fixture will not light.
The fuse blows or the circuit breaker
trips when the light is turned on.
Possible Cause
The power is off.
The circuit breaker is off.
There is a bad connection.
There is a defective switch.
The wires are crossed or the power
wire is grounding out.
5
Silicone Sealant
(not included)
Ensure the power supply is on.
Ensure the circuit breaker is in the on position.
Check to ensure proper wire connections are made.
Contact a qualified electrician.
Contact a qualified electrician.
Check the wire connections.
Contact a qualified electrician or call Hampton Bay
customer service 1-855-HD-HAMPTON.
Please contact 1-855-HD-HAMPTON for further assistance.
Solution
HAMPTONBAY.COM
