Idiomas disponibles
Idiomas disponibles
ACCESSORIES AND ATTACHMENTS
RECOMMENDED ACCESSORIES
WARNING
To avoid injury:
• Use only accessories recommended for this machine.
CARTON CONTENTS
UNPACKING AND
CHECKING CONTENTS
Carefully unpack the machine and all its parts,
and compare against the illustration following.
WARNING
• To avoid injury from unexpected
starting, do not plug the power cord into a
power source receptacle during unpacking
and assembly. This cord must remain
unplugged whenever you are assembling
or adjusting the band saw.
• If any part is missing or damaged, do not
plug the band saw in until the missing or
damaged part is replaced, and assembly
is complete.
No.
Description
1.
Band saw
2.
Fence
3.
Table assembly
4.
Miter gauge
5.
Open spanner
6.
Hex wrench (4mm, 6mm)
7.
Foot
INSTALLATION
1. Attach four feet
to the base of
band saw.
2. Mounting table assembly
• Remove the D-nut,
washers, and wing
screw on the saw
table.
D-nut
Wing
screw
Qty
x 1
x 1
x 1
x 1
x 1
x 2
x 4
3
• Follow instructions that accompany accessories.
Use of improper accessories may cause hazards.
• Use only accessories designed for this machine
to avoid injury from thrown broken parts or work pieces.
• Do not use any accessory unless you have completely
read the instruction or operator's manual for that
accessory.
3
1
5
• Slide the saw table past the blade and through the slot
moving to the frame, pulling the angle adjustment knob
away from the saw frame, Align the teeth on the saw
table bracket into the teeth on the angle adjustment
knob. Release the knob.
2
4
6
7
