Assembly And Adjustments - KNOVA KN SS-16LV Manual

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ASSEMBLY AND ADJUSTMENTS

UNPACKING
Carefully unpack the scroll saw and all of its parts. Compare
them against the list below. Do not discard the carton or any
packaging until the scroll saw is completely assembled.
CAUTION: do not lift the saw by the arm that holds the blade.
The saw will be damaged.
WARNING
To avoid injury from accidental startups,
turn switch OFF and remove the plug from the power
source outlet before making any adjustments.
A
INCLUDES (Fig. 1)
A - Scroll saw with attached light
B - Extra pin blade
STORAGE AREA (Fig. 2)
A convenient storage location
for the extra blade can be found
beneath the saw's table.
Prior to making adjustments, mount the scroll saw on a stable
surface. See "Bench mounting the saw."
ALIGN THE BEVEL INDICATOR (Fig. 3-6)
The bevel indicator has been factory adjusted. It should be
rechecked prior to use for best operation.
1. Remove the blade guard foot (1) using a Phillips head
2. Loosen the table bevel lock knob (3) and move the table
B
C
3. Loosen the locking nut (5) on the table adjusting screw (6)
under the table by turning it counter-clockwise. Lower the
4. Use a combination square (7) to set the table exactly
and blade, adjust the table angle until the space is closed.
Fig. 1
4
3
5. Lock the table bevel lock knob under the table (3)
6. Tighten the adjusting screw under the table until the tip
Fig. 2
5
screwdriver (not included) to loosen the screw (2).
until it is approximately at a right angle to the blade.
2
table adjusting screw by turning it clockwise.
90° to the blade (8). If there is space between the square
to prevent movement.
of the screw touches the table. Tighten the lock nut.
1
Fig. 3
Fig. 4
6
Fig. 5
5

Capítulos

Tabla de contenido
loading

Tabla de contenido