Idiomas disponibles
Idiomas disponibles
Hints on Installation
• Place the appliance on a bench away from water taps and sinks.
• Check that the voltage of the mains power supply corresponds to the value indicated on the appliance' s rating
plate. The manufacturer declines all liability for any accidents caused if the system is not correctly earthed.
• If the power outlet does not match the plug on the appliance , have the outlet repeated with a suitable type
by qualified personnel.
A Pitcher lid;
B Pitcher
C Boiler
D Disk filter
E Gasket
F Support base
G Power cable
H On/off switch
I
Pilot light
J
Safety valve
K Funnel filter
L 6 cup adapter
M Tube
How to prepare the Coffee
1. Check that the coffee maker is cold, and then unscrew it by holding the boiler with one hand and turning the
pitcher anticlockwise with the other.
2. Remove the funnel and , to prepare 6 cups of coffee, fill the boiler with fresh water until reaching the safety
valve ( visible inside the boiler),without exceeding it. On the other hand, to prepare 3 cups, fill the boiler with
water to the mark ( at round 2 centimeters) below the safety valve. Use fresh and soft water. Salty or hard
water will weaken the flower.
IMPORTANT: do not use the coffee maker without water in the boiler or alternatively using hot water for
faster operation .
3. Insert the funnel filter in the boiler. To prepare six cups of coffee, also insert the 6 cup adapter in the funnel filter.
4. Fill the funnel filter with ground coffee, without pressing it. Fill it a little at a time to prevent spilling the
ground coffee.
Product Description
Use and Operation
