Idiomas disponibles
Idiomas disponibles
39.
END OF SERVICE AND DAILY CLEANING
Aprire Open the door and remove the basket with the clean dishes.
•
•
Remove the overflow pipe from the basin filter by pulling it upward as indicated by the arrow in the figure below
and let the basin empty from the water content.
Close the door and press the drain button
•
Wait a few minutes, until the middle of the dashboard displays green light indicating the end of the cycle.
•
•
Turn off the dishwasher with the "on / off" button
WARNING !! (cleaning the outer surfaces)
•
Before starting with cleaning operations, disconnect the equipment's electric power supply located on the electric
panel, remembering that the machine remains powered when only the switch on the control panel is turned off.
Wash the stainless steel surfaces with warm soapy water, avoiding the use of detergents that contain abrasive
•
substances, scourers, brushers or steel scrapers, then rinse with a wet cloth and dry carefully.
Clean the control panel with a soft cloth moistened with water and, if necessary, neutral detergent. Do not wash the
equipment with direct or high pressure jets of water
•
The equipment must not be cleaned with water jets. In order to reduce the release of polluting substances to the
environment, it is recommended to clean the equipment with products that have a level of biodegradability above
90%.
Leave the door open for the entire period the machine will not be used.
40.
TROUBLESHOOTING
THE DISHWASHER DOES NOT
WASH WELL
THE GLASSWARE AND DISHES ARE
NOT DRY
pag. 27
Check if the intake filter is dirty and clean it thoroughly.
Check that the washing jets are not obstructed by solid residue
Check that the quantity of the initial detergent and/or the additions during the
The selected washing cycle is too short. Repeat the cycle.
Check that the basin temperature is between 50°C and 65°C.
Check that the dishes are positioned correctly in the baskets.
Check the instructions for the amount of rinse aid (see paragraph "dispenser
adjustment"). Check that there is rinse aid in the container and fill it up if
Check the quantity of rinse aid used (see paragraph "dispenser adjustment").
Check that the temperature of the rinsing water is between 80°C and 90°C.
washing cycle are correct.
necessary.
DOC. W010213 – REV.4
