Idiomas disponibles
Idiomas disponibles
30.
WALL FIXING KIT
Front-load models:
31.
WARNING MESSAGES DISPLAYED ON THE CONTROL PANEL
The device has two segments displays and a red LED in the middle that can display: errors, warnings or failures of
equipment
VISUALIZZAZIONE
AL 01
AL 02
AL 03
AL 04
AL 05
AL 06
AL 07
AL 08
AL 09
pag. 22
Provide holes in the
wall for fixing
brackets
Wall bracket fixing with
machine
The well cannot be filled within time limit. Please check the water supply tap, the water
flow rate in the supply network, the electrovalve functioning or clog. Please check if the
jets are clogged and the overflow pipe is correctly inserted into the syphon.
The well cannot be discharged properly. Please check the discharge system and
discharge pump functioning (if it is installed).
Boiler temperature is not reached. Please check the boiler safety clicson functioning
and the resistance.
Well temperature is not reached. Please check the well safety clicson functioning and
the resistance.
The detected temperature inside the boiler is too high. Please check the temperature
sensor functioning and if the relay of the board that turns on the resistance is closed.
Please note that scale incrustations could distort the sensor reading and cause inertia
of the high temperature of the resistance.
The detected temperature inside the well is too high. Please check the temperature
sensor functioning and if the relay of the board that turns on the resistance is closed.
Please note that scale incrustations could distort the sensor reading and cause inertia
of the high temperature of the resistance.
The water level in the well is too high. Please check the discharge system.
Disconnected well sensor. Please check the sensor connections.
Damaged well sensor. Please check the sensor functioning.
Hood type models
DESCRIZIONE
DOC. W010213 – REV.4
Provide holes in
the wall for fixing
brackets
Wall bracket fixing with
machine by screw,
supplied from factory
