• Meaning of displays
Warning
Caution
Warning
DO NOT DISASSEMBLE OR ALTER. Doing so may result in an
accident, fire or electric shock.
USE ONLY IN CARS WITH A 12 VOLT NEGATIVE GROUND. (Check
with your dealer if you are not sure.) Failure to do so may result in fire,
etc.
DO NOT SPLICE INTO ELECTRICAL CABLES. Never cut away cable
insulation to supply power to other equipment. Doing so will exceed the
current carrying capacity of the wire and result in fire or electric shock.
DO NOT INSTALL IN LOCATIONS WHICH MIGHT HINDER VEHICLE
OPERATION, SUCH AS THE STEERING WHEEL OR GEARSHIFT.
Doing so may obstruct forward vision or hamper movement etc. and
results in serious accident.
DO NOT ALLOW CABLES TO BECOME ENTANGLED IN SUR-
ROUNDING OBJECTS. Arrange wiring and cables in compliance with
the manual to prevent obstructions when driving. Cables or wiring that
obstruct or hang up on places such as the steering wheel, gear lever,
brake pedals, etc. can be extremely hazardous.
MAKE THE CORRECT CONNECTIONS. Failure to make the proper
connections may result in fire or product damage.
Caution
USE SPECIFIED ACCESSORY PARTS AND INSTALL THEM
SECURELY. Be sure to use only the specified accessory parts. Use of
other than designated parts may damage this unit internally or may not
securely install the unit in place. This may cause parts to become loose
resulting in hazards or product failure.
DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST.
Avoid installing the unit in locations with high incidence of moisture or
dust. Moisture or dust that penetrates into this unit may result in product
failure.
HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS. The
wiring and installation of this unit requires special technical skill and
experience. To ensure safety, always contact the dealer where you
purchased this product to have the work done.
ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A
SHARP METAL EDGE. Route the cables and wiring away from moving
parts (like the seat rails) or sharp or pointed edges. This will prevent
crimping and damage to the wiring. If wiring passes through a hole in
metal, use a rubber grommet to prevent the wire's insulation from being
cut by the metal edge of the hole.
This label is intended to alert the user to the
presence of important operating instructions.
Failure to heed the instructions will result in severe
injury or death.
This label is intended to alert the user to the
presence of important operating instructions.
Failure to heed the instructions can result in injury or
material damage.
