Lindy 38396-7 Manual De Usuario página 5

User Manual
Human Body Model: ± 4kV (contact discharge)

Operating Temperature: 0°C - 40°C (32°F - 104°F)

Storage Temperature: -20°C - 60°C (-4°F - 140°F)

Relative Humidity: 20 - 90% RH (Non-condensing)

Metal Housing

Colour: Black

Power Requirements: AC100-240V 50/60Hz

Power Consumption: Encoder 8W, Decoder 4W

Installation
Encoder 38396
1. POWER LED: This will flash red when the system is booting, will illuminate red when booting
successfully.
2. LINK LED: This will illuminate green when there is an input signal, will flash green when it gets no
signal.
3. RESET Button: Press and hold this button when the unit is powered-on until both POWER and LINK
LEDs will flash simultaneously, then release the button to restore the default settings.
4. DC 12V: Connect the 12VDC 1A PSU to an AC wall outlet and securely connector to the unit.
5. LAN (PoE): Connect to 1G Network Switch using a single RJ-45 Cat.6 or above cable to create a
distributed system. The unit can be powered via PoE if the connected Switch has this feature.
6. IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
7. IR OUT: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
8. USB HOST: Connect to a Computer for KVM function.
9. RS-232: Connect to a PC, Serial Controller or Serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 commands.
10. AUDIO IN: Analog Audio input interface which can be embedded into the HDMI stream for pass-
through over to HDMI and Audio outputs on the Decoder or be looped-out by the AUDIO OUT port on
the Encoder.
11. AUDIO OUT: Analog Audio output interface which can output the extracted audio from the HDMI IN
port or the audio from the local AUDIO IN port of the Encoder. It can also output the audio transmitted
from the MIC IN port of the Decoder in unicast mode (point-to-point connection).
12. HDMI OUT: Connect to a HDMI local Display.
13. HDMI IN: Connect to an HDMI source device.
English