Idiomas disponibles
Idiomas disponibles
SYMBOLS
To reduce the risk of injury, user must read
instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Warning
Li-Ion battery. This product has been marked
with a symbol relating to 'separate
collection' for all battery packs and battery
pack. It will then be recycled or dismantled in
order to reduce the impact on the
environment. Battery packs can be hazardous
for the environment and for human health
since they contain hazardous substances.
Do not burn
Batteries may enter water cycle if disposed
improperly, which can be hazardous for
ecosystem. Do not dispose of waste batteries
as unsorted municipal waste.
For indoor use only
T 2A
Fuse
Positive terminal
Negative terminal
Read the operator's manual.
Double insulation
EN
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use:
The machine is intended for dry sanding of wood, plastic,
filler and coated surfaces.
BEFORE OPERATION
1. CHARGING THE BATTERY PACK
a)
Do not use any charger other than that specifically
provided for use with the equipment.
b)
If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the
battery to cool down before recharging.
c)
The battery in your new tool is not charged when it
leaves the plant. Therefore it must be full charged
before using the first time.
d)
Please charge the battery to reach full or no less than
half charge before storage. If the tool will not be used
for long periods of time, charge the battery every 3-6
months.
CHARGING PROCEDURE (SEE FIG. A)
1)
Plug the charger into an appropriate outlet. The light
will be green.
2)
Slide the battery pack into the charger, the light
will turn to red to indicate the charging process has
started.
3)
When charging is completed, the light will turn to
green. The pack is now fully charged, unplug the
charger and remove the battery pack.
CHARGING INDICATOR
This charger is designed to detect some problems that
can arise with battery packs. Indicator lights indicate
problems (see table below). If this occurs, insert a new
battery pack to determine if the charger is OK. If the
new battery charges correctly, then the original pack is
defective and should be returned to a service center or
recycling service center. If the new battery pack displays
the same problem as the original Battery Pack, have the
charger tested at an authorized service center.
Light
Red on
Green on
Status
Charging
Fully Charged
17
