Idiomas disponibles
Idiomas disponibles
Step 1
* Turn over the bathtub on soft surface to make sure it is protected from scratches.
* Take off the plastic covers of screws and unscrew nuts and washers from the bathtub (these are pre-as-
sembled on bathtub).
* Place the bars on the bathtub, position washers and screws, then fix the screws but not tighten them,
because the bars could be adjusted during assembling.
Step 2
* Position the feet on the bar, fasten with washers, fastener washers and screws, but not tighten screws right
away.
* Adjust the feet to match the shape of the bathtub, bars could be adjusted if needed.
* Hold the feet firmly when tightening all screws, the feet must be secured fully to prevent any movement.
F: Adjustable feet
Step 3
* Assemble the overflow and waste (not supplied with the bath). Connect the bath trap (not supplied with the
bathtub) to the fitted bath waste and connect that to the bathroom's waste pipes.
Step 4
* Place the bath to the desired location and water test the bath for any leaks before use.
INSTALLATION
Do not tighten the
screws betore
adjustment.
C: Nut
E: Fastener
washer
D: Washer
A: Bar
Adjustment
space
4
