Idiomas disponibles
Idiomas disponibles
Installing and pairing smart dimmer
The dimmer switch is connected through the app and will only operate on your home's
2.4GHz Wi-Fi network. Most new routers are dual-bandwidth (both 2.4GHz and
5GHz), ensure you select the 2.4GHz network which covers a wider range than the
5GHz. To make sure your phone is on the 2.4GHz network, either select it in the list of
available networks on your phone or go into the router settings and temporarily de-
activate the 5GHz network (you can activate it again after pairing is done).
If this is not possible and the dimmer switch is not found, try putting the dimmer
switch in pairing mode by holding the ON/OFF button for 5 seconds (or until the
indicator lights fl ashes red), then walking a short distance away from the router. Due
to the short range of 5GHz networks, your phone should auto-connect to the 2.4GHz
at this point. Once connected, you can start pairing in the app. You can pair as many
devices as you want at the same time.
Name your own or select
from the list of standard
rooms
For additional support, visit www.liteline.com/WiZsupport
Press the 'Add a device'
button and enter your
Wi-Fi password
Select the 'Wi-Fi Switch'
and continue with prompts
to connect your device
