Idiomas disponibles
Idiomas disponibles
How to start
Locate all the elements before starting
1.
Feet anti vibration
2.
Tube turbine
3.
Guide tube tank
4.
Knob
5.
Nozzle
6.
Intake
7.
Pressure control valve
8.
Plug
9.
Switch
10. Drain Valve
11. Thermometer
12. Thermostatic mixer
13. Fill valve
14. Wrench heat (1 ")
15. Wrench cold (1 ")
16. Sewage input
17. Sewage return
How to install the unit
1.
Sure that the tank is level, rectify it it is necessary the leveling legs (1)
2.
Fix the turbine tube (2) into the guide tube (3) tank, tightening the knob (4) to ensure the
chosen height. To be drained, turn the drain valve (10) counter clockwise. Drain tube Ø 32mm
(note, this valve (10) is charged on the side of the bath according to the model of the tank. The
drain valve can be found in the lower part of the tank depending of the model
3.
Connect the Nozzle (5) in the intake (6).
4.
Turn the pressure control valve (7) fully clockwise, then fully to the left to lubricate the
plunger assembly.
5.
Connecting to the mains (plug grounding) (8).
How to run the unit
1.
To run the unit move the switch (9) to On position. To stop working the unit move the switch
(9) to Off position.
How to fill the tank
1.
Open Wrench heat water (14) and Wrench cold (15).
2.
Ensure that the drain valve (10) is closed.
3.
Fill the tank using the thermostatic valve (12) and / or the filling valve (13). The water level
must be a maximum of 10 cm below the edge of the tank and at least 15 cm above the pump.
4.
Turn the pressure control valve (7) fully clockwise. This provides maximum pressure and
agitation. Turn the switch (9). Adjust the pressure of the pressure control valve (7) to achieve
the desired level of pressure and agitation.
How to drain the tank
1.
Verify that the turbine is OFF
2.
Remove any loose objects or debris that may be present in tank.
3.
Proceed to empty the tank, open the drain valve (10). To clean the waste water using a sponge
/ towel
Operation and maintenance manual Rev2
27
