Idiomas disponibles
Idiomas disponibles
SP6683 DIRT HOUND.qxd
3. After using the vac to pick up liquids, the
filter must be dried to reduce the risk of
possible mildew and damage to the filter.
4. When the liquid in the drum reaches a
predetermined level, the float mechanism
will rise automatically to cut off air-flow.
When this happens, turn off the vac, unplug
the power cord, and empty the drum. You
will know that the float has risen because
vac airflow ceases and the motor noise will
become higher in pitch, due to increased
motor speed.
IMPORTANT: To reduce the risk of damage
to the vac do not run motor with float in
raised position.
Emptying the Drum
!
WARNING: To reduce the risk of
injury
from
unplug power cord before emptying
the drum.
1. The vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the drum.
2. Another option is to remove the power
assembly. Pull the flexible latches
outward on each side of the lid to
release from the drum.
3. While holding the latches out, lift the
power assembly up and away from the
drum.
4. Lay power assembly upside down on a
clean area while emptying drum.
5. Dump the drum contents into the proper
waste disposal container.
!
WARNING: To reduce the risk of
back injury or falls, do not lift a vac
heavy with liquid or debris. Scoop or
drain enough contents out to make
the
vac
light
comfortably.
6/27/07
1:49 PM
Operation
accidental
starting,
enough
to
lift
Page 9
(continued)
Cord Wrap/Carry Handle
The wet/dry vac has a convenient cord
wrap area/carry handle design on the rear
of the vac. Simply, wrap the power cord
around the handle and snap the connector
on the plug to a wrap of the cord and the
cord is wrapped for storage.
Moving the Vac
Should it become necessary to pick the
vac up to move it, DO NOT pick the vac up
by the lid handles unless dust drum is
empty. To avoid dropping the vac due to
latches
releasing
breakage, pick the vac up by the lip of the
dust drum.
Blowing Feature
Your vac features a blowing port. It can
blow sawdust and other debris. Follow the
steps below to use your vac as a blower.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might be
inhaled.
!
CAUTION: To reduce the risk of
hearing damage wear ear protectors
when using the vac/blower for
extended hours or when using in a
noisy area.
9
or
possible
part
