EN
5.1 - REPLACEMENT OF THE
SAFETY DEVICE AGAINST
OVERCHARGE (FUSE) (FIG. E)
In case of overcharge or malfunction,
the fuse burns out and interrupts
the electric circuit to protect the
compressor.
After eliminating the cause of fuse
starting, replace it:
1. Untighten the fuse cover/support (2);
2. Remove the fuse and replace it for
a new one;
3. Place and tighten the cover/support;
Never use a fuse with nominal
current higher than the specified
on technical specifications.
5.2 - CLEANING AND STORAGE
Cleaning
After each use, clean every component
of the machine. Rub the equipment with
a clean and damp cloth or blow it with
low pressure compressed air. A careful
handling protects the equipment and
extends its lifespan.
Keep the machine and its ventilation
openings unobstructed. Clean them
regularly to avoid clogs.
Storage
When the hammer isn't being used,
it shall be kept inside a dry place,
corrosive steam free and away from
children's reach.
6. PROTECTION OF THE
ENVIRONMENT
The packaging is made of
recyclable materials, which
can be disposed on local recycling
points.
Never place power tools in
the domestic waste!
According to the European
Directive 2012/19/CE on electrical
and electronic equipment waste and its
transposition into national law, power
tools must be collected separately
and delivered to the collection sites
provided for this purpose.
You can obtain information regarding
the disposal of the compressor through
the person in charge for the recycling
in your city.
7. CUSTOMER SERVICE
Phone: 00351 256 331 080
Website: www.centrallobao.pt
21