VITO PRO-POWER Manual De Instrucciones página 20

EN
ON/OFF SWITCH
The "ON/OFF SWITCH" control the
"Multi-purpose Table Saw" ON/OFF
positions.
The "ON/OFF SWITCH" buttons are
located on the front left side of the
"Cutting handle" . Two kinds colour
switch button: The green button, "-"
logo print on the face. It represents
"ON". Press the "-" button down
when you connect up the power, the
machine will be enter to working
position now. The red button, "O"
logo print on the face. It represents
"OFF". Press the "O" button down
when you connect up the power, the
machine will be stop working.
CHOP CUTTING
The cutting head is gently pushed
down to cut through the workpiece.
1. Place the workpiece on the rotary
table and against the fence in the
desired position. Secure with clamp
as appropriate.
2. Grasp the "Cutting Handle".
3. Turn on the motor, allow the
blade to reach full operating speed.
4. Press and hold the "Cutting
Head Release Lever" to release the
"Cutting Head".
5. Gently lower the "Cutting Head"
to its lowest position, cutting through
the workpiece.
6. After the cut is completed, turn
of the motor by releasing the trigger
switch. Allow the blade to come to
a complete stop. Allow the "Cutting
Head" to rise to its upper position.
7. Only remove your hands or
the workpiece from the machine
when the "Cutting Head" is in
its upper position with the blade
teeth completely covered by the
"Retractable Blade Guard".
ANGLE CUTTING:
THE ROTARY TABLE
- Any angle from 45º left to 45º
right is available, and a protractor
scale can be found to the front of the
"Rotary Table".
- Positive stops are provided for
every 5º of angular movement.
NOTE: The rotary table must always
20
be locked into position with the
"Mitre Angle Locking Screw" even if
a positive stop is selected.
the mitre angle
screw off
locking screw
1. Screw off the "Mitre Angle
Locking Screw".
This is found at the front right hand
side of t he tables base near the 35º
index mark.
2. Turn the "Rotary Table" to the
required angle. To aid setting, an
index mark is machined into the
table just in front of the table insert.
3. Tighten the "Mitre Angle Locking
Screw" securely when the desired
angle has been selected.
Cutting thickness 55mm
Attention:
When the table rotates to 0º,
and the "Mitre Cutting Head" was
vertical to table face.
The cutting wood thickness not more
than 55 mm, and the cutting width
is 110mm.
Attention:
When the table rotates toward
left to 45º, and the "Mitre Cutting
Head" was vertical to table face.
The cutting wood thickness not more
than 55 mm, and the cutting width
is 65mm.
Attention:
When the table rotates toward
right to 45º, and the "Mitre Cutting
Head" was vertical to table face.
The cutting wood thickness not more
than 55 mm, and the cutting width
is 65mm.
mitre
NOTE: The "ANGLE CUTTING "
can now be made using the same
techniques as previously described
Cutting width in chop cutting.
110mm
Bevel locking