Strong SRT ANT 45 DVB-T/T2 Manual Del Usuario página 4

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
1
4
2
5
If your receiver does not support 5 V antenna power, then please follow the next steps:
4.2 To power the antenna with external power adapter
1. Switch OFF your receiver and disconnect it from the 230 V mains power.
2. Take the short coaxial (IEC Male to IEC Female) cable. Connect the IEC Male end to your
receiver. Normally the input connector on your receiver is marked as "ANT" (in) or as "RF" (in).
Refer to the user manual of your Digital Terrestrial Receiver.
3. Connect the other end of the cable to the connector on the power injector that is marked
as "Receiver".
4. Take the supplied "long" coaxial cable and connect the end with the "F connector" (screw
type connector) to the antenna. Carefully press the inner lead of the cable into the Female-F
connector at the back of the antenna. Turn the covering nut clockwise with your HANDS
until it is fixed.
5. Connect the other side of the cable to the connector at the power injector, it is marked as
"Antenna".
6. Insert the adapter to the 230 V main power and insert the connector at the end of the lead
to the power injector - it is marked as "6 V".
7. Proceed to chapter 5.0 "Installation of the antenna".
4
3
1. Digital TV
2. STB
3. Active DVB-T/T2 Outdoor
4. HDMI or SCART cable
5. Coaxial cable
6. Water-Drop Loop
6
PART 2
Fig. 4
Antenna.
(optional)
(recommended)
loading