Instructions for Use
Safety
This section contains the information, prescribed by the Low Voltage Directive
2014/35/EU, which is essential for the compliance and observance of the safety
regulations both generally and in relation to the specific use of the product.
Failure to comply with these instructions and the other instructions contained in this
manual may render the safety conditions envisaged in the design phase inefficient and
cause accidents to those operating the product.
Agilent Technologies declines all responsibility for damage to the product or for the
physical safety of the operator or third parties deriving from the non-observance of the
safety rules indicated in the technical documentation.
EMC Warnings
EN 55011 Class A Warning
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
The IDP-10 was tested with an I/O cable (for remote control) employing a clamp-on
ferrite bead combined foil-braid shields and metal shell connectors with the shields
connected to the IDP-10 chassis. Compliance with FCC Part 15 rules and the
European Union's EMI requirements cannot be assured unless this type of I/O cable
and ferrite bead is used.
Failure to install the unit in this way may result in the failure to meet the
requirements for radiated emissions and susceptibility.
The ferrite bead must have the following characteristics:
Ferrite type: Broadband
Impedance characteristic (Table 13).
Large enough to fit over the cable being used.
Table 13 Impedance Characteristic
Frequency (Mhz)
25
100
300
164
Nominal Impedance (Z)
25
250
420
Agilent IDP-10 Dry Scroll Vacuum Pump User Manual
