Hitachi Koki CW 40 Manual De Instrucciones página 13

PLAIN-END BLADE REMOVAL (FIG. F, G, H)
WARNING
To avoid injury, do not touch the bottom of the
tension knob (1) when operating the quick release
tension lever (2).
1. To remove blade, loosen the blade tension by lifting
the quick release tension lever (2).
Fig. F
1
2. Loosen upper blade holder (4) by turning the blade
holder lock knob (5) counterclockwise.
NOTE: The hex set screw (6) on the right side is
used for fine adjustments and is only adjusted if the
blade is not perpendicular to the table.
Fig. G
5
9
3. Tilt the table 0° and tighten the table lock knob (7).
Loosen the lower blade holder lock knob (9) under
the table on the left side of the lower blade holder (8)
by turning it counterclockwise. (Fig. G, H)
4. Remove blade (1) from the upper (4) and lower blade
holders (8) by pulling forward and lifting the blade
through the access hole (10) in the table (11).
(Fig. G, H)
Fig. H
10
2
6
4
1
8
1
11
7
PLAIN-END BLADE INSTALLATION (FIG. H, I, J)
In order to avoid uncontrollable lifting of the
workpiece, the teeth of the blade should ALWAYS
point downward.
1. Install the new blade (1) through the access hole (10)
in the table (11) with teeth pointing down. (Fig. H)
2. Insert the new blade (1) into the lower blade holder
slot (13), then tighten the lower blade holder knob
(9). (Fig. I)
Fig. I
3. Tilt the table to 0° bevel setting and lock the bevel
knob (7). (Fig. H)
4. Insert the other end of the blade into the upper blade
holder slot (12-Fig. I) and then tighten the quick
release tension lever (1-Fig. J).
NOTE: Apply slight downward pressure against the
upper arm (3) when installing the blade into the
upper blade holder. (Fig. I)
5. Tighten the tension on the blade by turning the
tension knob (2) clockwise. Check the tension the
blade. If too loose, turn knob clockwise. Do not make
it too tight or blade will easily break in used. (Fig. J)
NOTE: The quick release lever must always be down
to make the tension adjustments, Release the quick
release lever upward only during blade changing
operations. If the blade is over-tightened, the lever will
be difficult to lower and could result in damage to the
blade holder or arm assembly.
Fig. J
1
– 13 –
WARNING
3
5
12
1
9
13
2
English