Kichler Surrey Climates Manual De Instrucciones página 7

HANGING THE FAN
Step 3. Loosen the two set screws and remove the cross pin and clip on the top
coupling of the motor body.Carefully feed the fan wires and safety cable through
the downrod. Thread the downrod onto the motor coupling until the cross pin holes are
aligned. Next, replace the cross pin and clip, and tighten both set screws. (Fig. 7)
Step 4. Slip the coupling cover, canopy hole cover and canopy onto the downrod.
Carefully reinstall the hanger ball onto the downrod . Make sure the cross pin is in the
correct position and the set screw is tight and the wires are not twisted . ( Fig. 8)
Step 5 . Now lift the motor assembly into position and place the hanger ball into the
hanger bracket. Rotate until the "Check Tab" has dropped into the "Registration Slot "
and seats firmly. ( Fig. 9) The entire motor body should not rotate if this is done
correctly.
WARNING: Failure to properly seat the "Check Tab" can damage the ceiling fan during
operation.
Clip
Set Screw
Downrod
Clip
Set Screw
Cross Pin
Motor Body
Fig. 7
Canopy
Hanger Ball
Canopy Hole Cover
Coupling Cover
Motor Body
Fig. 8
Registration Slot
Check Tab
Fig. 9
60" Surrey Climates™
Cross Pin
7