Idiomas disponibles
Idiomas disponibles
5.
Align Cover Tabs with arm slots and install arm cover
plate. Secure by fastening the two Phillips head screws
to 20 in-lbs (2.3 N-M).
N
ote:
Ensure the luminaire supply leads do not get pinched
between cover and mounting arm. (Figure 5.)
6.
Install pole cap after completion of luminaire installation
and wiring.
Wall Mount
Tools Required
#2 Phillips head screwdriver, torque wrench.
N
ote:
Hardware and tools to mount wall plate to wall not
supplied.
1.
Pull the supply wires out of junction box (not supplied)
and through the large hole in the center of the wall
plate.
2.
Secure attachment plate to the wall using four bolts
(not included).
3.
Follow instructions step 3 through 5 from pole mount
arm configuration.
Wall Plate
6x8 Plate Size
Figure 6.
Mast Arm Mount
Tools Required
1/4" Allen wrench, #2 Phillips head screwdriver, torque
wrench, drill and 7/16" drill bit.
1.
Slip the mast arm mounting assembly over the mast
arm (making sure not to pinch any supply leads). Make
sure the mast arm is fully seated into the mast arm
adapter as it should bottom out against the adapter.
2.
Secure the mast arm adapter to the mast arm with
the (4) set screws. Level the mast arm adapter while
tightening the set screws. Torque to 120 in-lbs
(Figure 7 .).
3.
Drill a 7/16" hole through the mast arm and install the
throughbolt and nut. Use care when drilling this hole
so as not to damage any wires within the mast arm.
Torque to 120 in-lbs (13.6 N-M) (Figure 7 .).
Installation Instructions – Prevail Petite / USSL Petite
4.
5.
Figure 7.
6.
.44 dia
[11.20]
7 .12
8.00
[180.85]
[203.20]
Wireway
(Center Hole)
Figure 8.
7 .
8.
Surface Mount
Tools Required
#2 Phillips head screwdriver, torque wrench, 7/16" open end
wrench or 7/16" ratchet wrench.
N
Cooper Lighting Solutions
Open fixture door by loosening the (4) Phillips head
screws (or thumb screws if supplied) on the door.
(Figure 8.)
Remove wire grommet for fixture wires at the back of
the fixture. (Figure 8.)
Level Surface
Throughbolt
Fold fixtures wires and mast arm adapter wires out of
the way and slide fixture on to the mast arm adapter.
Tighten the three joining screws to 20 in-lbs (2.3 N-M),
and install the plastic plug over the center screw.
(Figure 7 .)
Wire
Grommet
Open Fixture Door
Make wire connections inside the fixture. Refer to wire
diagram for power connections (Figure 4.). Connect the
supply wires to appropriate luminaire leads.
Tuck wires into the fixture and install fixture door.
Tighten the (4) fixture door screws to 20 in-lbs. (or
tighten door thumb screws).
ote:
Hardware and tools to mount the wall stud plate to
wall are not supplied. Use 1/4" diameter fasteners
for the appropriate mounting surface (concrete, brick,
wood, etc)
IB514105EN
Mast Arm Pole
(2" Tenon Arm)
Set Screws
Joining Screws
Installation instructions
3
