Idiomas disponibles
Idiomas disponibles
Function introduction:
1. Charging: Find the charging port on the right side frame of the battery, connect the
charger to charge. When the battery is fully charged, the charger light changes from
red to green.
.
2
Power On/Off: Long press the power button to turn on/off the display power.
3. Display: After the power is turned on, the display screen will light up and display
real-time speed (km/h) and single mileage (km) by default. Short press the "i" button
to display the information to switch between single mileage (km), total mileage (km),
maximum speed (km/h), average speed (km/h), and riding power.
4. Headlight: Press the light button to turn on/off the headlight.
5. PAS Mode: You must turn on the battery to use the e-bike in pedal-assisted mode.
Power assist is triggered when you pedal forward, and stops when you stop pedaling,
sometime with a delay. If no power is needed, turn off the power of the battery.
6. Electric Mode: You do not need to pedal the e-bike if you use the hand throttle. The
throttle can be controlled by twisting it from the resting position, and the farther the
throttle switch is from resting position, the more power is sent to the motor to
accelerate the e-bike.
7. Cruise Control : Cruise control will be triggered when you holding thumb throttle
and riding at the same speed for 8 seconds, and it will be released by braking/pedaling
or throttling.
8. Push Mode: Long press the "-" button, the electric bicycle will enter the push mode.
The electrical bike runs at a constant speed of 6 km/h. Release the "-" button, the
electric bicycle will immediately stop power output and return to the state before push.
EN
04
