Maintenance; Troubleshooting - Ritmo STARGUN SOLO Manual De Uso Y Mantenimiento

8. MAINTENANCE

Warning
•
Disconnect extruder from electrical line before performing any
maintenance intervention.
Let specialized technicians to perform maintenance on the welder.
•
Before any intervention, wait for the complete cooling of the extruder.
COMMUTATOR/BRUSH SEATER CLEANING
Use a brush seater stone to clean the commutator. Repeat procedure at
least once per brush replacement.
AIR FILTER CLEANING
Pulire periodicamente con pistola ad aria compressa la scatola elettrica in
corrispondenza delle feritoie per l'aria.
Warning
Do not use corrosive detergents
We recommend to clean the STARGUN SOLO after every use.
EN
18

9. TROUBLESHOOTING

The system is equipped with a self-diagnostic of the hardware at the startup.
If any error shows up, unplug the extruder and restart. If the error persists,
contact an authorized service center.
Example of startup diagnostic error:
C:0
Once the start-up check is over, a new self-diagnostic system is initialized
The display may show at any time the following:
# Err description
No feedback from the temperature sensors.
Probable cause:
5
temperature controller fault.
Contact an authorized service center
Cannot stabilize the blower air temperature
Probable causes:
a. Sudden change of working conditions (e.g. the blower hose is
clogged)
15
b. Temperature probe fault.
Turn off/on the extruder and make sure that the air flow is not
clogged.
If the error persists, contact an authorized service center
The blower air temperature is too high
25
contact an authorized service center
Cannot control the blower
30
contact an authorized service center
The wiring bow temperature is too high (above 95°C/200F)
35 Make sure that the environmental conditions are suitable to the
extruder (e.g. avoid direct sunlight, etc..)
The specifications of the device and the data entered in
this manual are subject to change without notice from the manufacturer.
Reproduction of this manual, including in part, is
prohibited.
Full parts lists and technical documents are available online at
www.ritmo.cloud.
Help in the event of problems:
S.p.A.
via A. Volta, 35/37 - Z.I. Selve
35037 BRESSEO DI TEOLO (PD)
ITALY
Tel. +39.049.990.1888
Fax +39.049.990.1993
[email protected]
DISPOSAL
Do not dispose of in the household trash. Add the device that is no
longer able to be used to a separate collection for the purpose of
environmentally friendly recycling.
Contact Ritmo S.p.A. for further info.
CHK 4
R:0
ERR: 0