Idiomas disponibles
Idiomas disponibles
Pull the motor trigger P and button B to start the extruder.
Feed the melting chamber with the plastic rod on your suitable side.
Do not use both rod feeders at the same time! Wait till the rod
has been consumed in one side before feeding the opposite side.
Leave the extrudate to come out of the tip hose for about 10 seconds and
make sure that it is plasticized correctly, then proceed with welding.
Make sure the extrudate is flowing smoothly.
WARNING! Do not let any electrical wire come into direct
contact with neither the extruded nor the hot surfaces!
20
EN
B
P
OPERATING INSTRUCTIONS
• Place the shoe on the two sheets to be welded (example X and Y). Preheat
the welding area for a few seconds before starting the extrusion.
• Apply some pressure while moving the extruder.
X
• Follow the welding direction as indicated by the arrow in the figure. The
blowing of hot air for the preheating of the material must always precede
the supply of the extruded material. An incorrect preheating does not
guarantee the interpenetration of the filler material with the sheets to be
welded ("gluing effect").
Prevent the extruded material from clogging the air hose.
At the end of the welding, place the extruder on the appropriate support.
SHUTDOWN
Push buttons 6 and 7 together: the air temperature decreases to cool down
the heating resistors, while a countdown starts on the display.
COOLING
Please wait 97 sec
CAUTION! The shutdown procedure does not provide for the complete
cooling of the various hot parts of the extruder but only serves to lower the
temperature of the heating resistors to ensure a longer duration. To avoid
accidental burns, wait for the parts to cool naturally.
Y
7
6
