Bresser Thermo Hygro Quadro NLX Manual De Instrucciones página 12

When changing the batteries, always remove the batteries
from both the base unit and the sensor and reinsert them in
the correct order so that the radio link can be re-estab-
lished. If one of the two devices is operated via a mains
power connection, the power connection must also be
briefly disconnected for this device when the batteries are
changed. If, for example, only the batteries in the sensor
are replaced, the signal may subsequently not be received
at all or not be received correctly.
Note that the actual range depends on the respective con-
struction materials used for the buildings as well as the re-
spective position of the base unit and the outdoor sensor.
External influences (various radio transmitters and other
sources of interference) can greatly reduce the possible
range. In such cases, we recommend finding other locations
for both the base unit and the outdoor sensor. Sometimes
moving the sensor by just a few centimeters is enough!
Though the remote unit is weather proof, it should be
placed away from direct sunlight, rain or snow.
8 Power supply
Base unit
1.
2.
3.
4.
12 / 80
Insert the DC plug into the connection socket on the
base unit.
Insert the Euro plug into the mains power socket.
The device is powered on directly.
Wait until indoor temperature is displayed on the base
unit.
NOTICE! For permanent operation, mains power supply
is recommended. Alternatively, operation using batter-
ies is also possible to maintain the time setting in the
event of a power failure. In battery operation, the sta-