Programming; Cofee Doses; Hot Water; Pre-Set Values - Wega AIRY EVD Manual De Uso Y Mantenimiento

7.

PROGRAMMING

The machine is programmed by default. Should the
settings need to be modiied, proceed as described in
the following paragraphs:

Cofee doses

7.1
• Always programme the right
push-button panel irst. This way,
both push-button panels are au-
tomatically programmed. If nec-
essary, programme the left later;
• place the cup under the dispens-
ing spout;
• press the STOP/PROG. button for
at least 5 seconds until the STOP/
PROG. button lashes;
• press the desired dose button, for
example ;
• to confirm the dose, press the
button again;
• repeat this operation for the other
dose buttons;
• when the programming is com-
plete, press the STOP/PROG. but-
ton, or wait 20 seconds.
The programming of every dose must be
carried out with ground cofee and not with
previously used cofee dregs.
The system automatically exits the
programming mode 20 seconds after the
last operation was carried out.
Do not remove the ilter holder from the dispensing group when
cofee is being dispensed.
Do not insert your ingers or any other objects into the ilter holder.
User manual

Hot water

7.2
• Place the pot under the hot wa-
ter spout;
• Press the STOP/PROG. button
for at least 5 seconds until the
STOP/PROG. button lashes;
• Press the
button;
• To conirm the dose, press the
button again;
• When the programming is com-
plete, press the STOP/PROG.
button until all of the LEDs on the
push-button panel are lit.
Avoid contact with the hot water nozzle,
do not place your hands or other body
parts near the hot water nozzle tips.

Pre-set values

7.3
Use this procedure to reset the factory values both for
the cofee beverage doses. Proceed as follows:
• Turn the machine of;
• restart the machine by pressing and holding the
and STOP/PROG. buttons on the right-hand
push-button panel;
• only release the buttons when the STOP/PROG. but-
ton LEDS are lashing on all the push-button panels;
• turn the machine OFF and ON.
AIRY
39 160
of